Re: Printing on Al - my experience

[Jacek Gonsalves <jacek@jagnight.com>]

Hi Rajul,

Thanks very much for all the information!
Though wouldn't just the ground of Acylic gesso give you the tooth it  
would need to apply coats of whatever alternative process your using?

Btw what is your consistency,/mixture of your 30ml Gum Arabic to water?

Cheers
Jacek


Quoting Rajul <eyeear@shaw.ca>:

> I was able to get good prints on Al by the method I describe below.
> Although I continue to fine-tune the procedure, the set of prints I
> have are happy outcomes - flaws and all. I am thankful that gum arabic
> served to increase the viscosity sufficiently to keep the sand flour
> particles in suspension through the coating steps.
>
> 1. CLEANING  PLATES:
>     Clean plates w soapy water (tear drop test for cleanliness).
>     Clean 3x w 99% isopropyl alcohol.
>     Mask borders if desired w painters' tape or tackier tape.
>
> 2. GROUND  PREPARATION:
>     30 ml of 14 Baume Gum Arabic
>     60 ml water
>     Add acrylic gesso (I used Stevenson's) to desired opacity
>     10 g Sieved Sand Flour
>     Pot. Dichromate powder equivalent to the concentration used to get
> shadows to 		print
>   	(I found 2% more than enough)
>
> 3. APPLICATION  OF  GROUND:
>     a. Use a dampened, squeezed out roller
>     b. Pour an aliquot of the stirred ground on to plate and apply it
> uniformly w roller
>         IMPT: helps to have roller barely charged. Hold it in a
> sandwich bag while c and
>   		d (below) are carried out to prevent it from drying
>     c. dry coat w hair dryer set on hot
>     d. UV for 1 min to harden entire coat
>     e. Turn plate 90 degrees and repeat b-d till ground is of desired
> thickness.
>
> 4. GELATIN SIZE:
>     4% gelatin hardened w HCHO and containing ever clear is applied on
> 3 				consecutive days (allowing gelatin to dry for 24 hours between
> each application).
>
> 5. APPLICATION  OF  GUM  EMULSIONS:
>     - Use a 10% amm. dichromate stock for mixing w gum and water   
> color pigment
>     - It HELPS to dampen plate w a wetted, hand-wrung towel before   
> brushing on
>   	emulsion with a dampened, flicked, foam brush to get streak-free spreads.
>     - dry coat w an overhead fan.
>
>     - If, during development of an exposed gum layer bubbles form between the
> 	ground and the Al surface, REJECT the print: the dried bubbles prevent
> 	close contact between the negative and the printing surface during   
> subsequent
> 	gum passes. Rate of bubble formation was 1 in 24 plates in my hands.
>
> 6. CYANO  PASSES:
> 	Can be done on top of gum. This requires long exposures (~1 hour in the
>   	shade on a sunny summer day).
>
> 	- If there was any balling of the gelatin when the gum emulsion was applied
> 	   (resulting in raised dots that may be colored or white), the cyano
> emulsion will 	   clear them. In some prints, I found these dots to be
> a windfall!
>
>
> I hope the above persuades more gummists to take on Al. Questions or
> comments are welcome.
>
>
> Rajul