Ender100@aol.com
Date: 07/21/02-12:46:47 AM Z
Hi Terrance,
Lenswork Magazine (www.lenswork.com) is the one you are referring to. The
prints are really nice....and REALLY low cost.
Are you planning on using a bit mapped negative or screened negative?
Mark Nelson
In a message dated 7/21/02 2:25:43 AM, terence@intekom.co.za writes:
<<
Hello all i have done tons of searches for the curves i would need to
apply to my file before i send it
to my prepress house to have a positive made, for silver prints.
I have found curves for platinum and inkjets but none for imagesetter
output, i know Dan Burkholder,s book is an option but where i am based
it would take forever for the book to get here, also only needing
a starting point for the curve would it would be too much money for me
at this point especially when converting $ to my currency.
Dave Focos PDF availble freely on the net gives one most of the important
info, all except the curve, his info is based on Platinum.
I have heard that one of the specialist fine art magazines uses a very good
curve for the prints available on their site.
If nobody has a curve i could use as a starting point, am i right in
assuming that the curve needs to be pretty flat in the centre between the
highlight and shadow areas, or am i just showing my ignorance of this medium
;-)
Thanks a lot in anticipation.
Regards
Terence Hogben >>
This archive was generated by hypermail 2.1.5 : 09/19/02-11:11:01 AM Z CST