RE: Gum Roller-Coating

From: Don Bryant ^lt;dstevenbryant@mindspring.com>
Date: 04/06/06-10:32:30 AM Z
Message-id: <001601c65997$b34c1780$6401a8c0@athlon64>

Kerik and all,

I certainly don't need to verify Kerik's advice here but I've adopted the
foam roller method also and it does work very well.

I will also point out that Chris Anderson turned me onto Connoisseur brand
hake brushes and they are the best ones I've ever tried for gum, making very
smooth even coats with most pigments (some pigments seem to have an oily
consistency causing fisheyes but these are problematic with the roller too.)

It has also been my experience that the foam rollers require more material
than a hake brush but that factor is offset by the smooth coating.
Occasionally due to the way I mix my gum/pigment/water mixture I have tiny
air bubbles left on the coating which I smooth out with a badger hair
blending brush (also recommended by Chris.)

The roller method does require a little practice to get the hang of the
smooth roll on.

Don Bryant
  

-----Original Message-----
From: Kerik [mailto:kerik@kerik.com]
Sent: Thursday, April 06, 2006 12:10 PM
To: alt-photo-process-L@usask.ca
Subject: Gum Roller-Coating

> Marek, how do you keep from getting a pebbly texture in the gum? Am I
> just not using a light enough touch, or what?

Here's how I've used foam rollers for applying gum for the last 5 years:

1) Use the white-colored foam rollers. They have the smoothest and densest
texture to them. They come in 3" and 6" lengths. Since I usually print
large, I use the 6" size. It's important to not use the more open-cell
foam found on some rollers - these can result in pebbly or rough texture.

2) For a 14x17 print I use 10 ml of gum and 10 ml of dichromate solution.
I also add some everclear - 15 drops or so, but this is optional.

3) After mixing well, I pour the solution onto a sheet of glass or other
smooth, clean, non-absorbent surface.

4) I then roll the roller back and forth over the solution until most of
it is absorbed evenly into the foam roller.

5) I then roll the solution onto the paper starting with rather firm
pressure to squeeze most of the solution out of the roller and onto the
paper on the first series of passes across the paper, then roll again
perpendicular to the first series of passes. I continue rolling with less
and less pressure until just the weight of the roller is pressing on the
paper. At this point, the surface becomes very, very smooth. I really
dislike the gritty gum look and Stuart and I found this approach gave
consistently smooth, even gum coats.

This is much easier and quicker to do than it is to describe. I've taught
this approach to many students in workshops and they've all taken to it
quickly.

Kerik Kouklis
www.kerik.com
Platinum/Gum/Collodion
Received on Thu Apr 6 10:32:42 2006

This archive was generated by hypermail 2.1.8 : 05/01/06-11:10:24 AM Z CST