RE: Photopolymer Plate Options
Christina, I accidentally deleted you other post, but you can download Jon Lybrook's curve from his site for the KM73 plates: http://www.lytescapes.com/procedures/polymer_photogravure.html Mark -----Original Message----- From: SusanV [mailto:susanvoss3@gmail.com] Sent: Friday, February 16, 2007 8:13 AM To: alt-photo-process-l@usask.ca Subject: Re: Photopolymer Plate Options Christine... Didn't see the PDFs at the Boxcar website, but I went to the Toyobo (manufacturer of Printight plates), and read the info for KM73. Water washout is at 15-25C, or 59-77F. Whew... now I don't have to re-do my tests ;o) Maybe what you read was for something different? susan On 2/16/07, SusanV <susanvoss3@gmail.com> wrote: > Christina... I'm sure your information is right... I just meant that I > was surprised that I'd somehow missed that, and it may well have a > dramatic effect on my first test results I've just done this week. > I'll go download those PDFs. > > thanks! > susan > > On 2/16/07, Christina Z. Anderson <zphoto@montana.net> wrote: > > Susan, > > I downloaded the pdfs on EcoEtch Printight KM73 and Ecoetch 43-SB and both > > say that. Hmmm... > > > > Chris > > ----- Original Message ----- > > From: "SusanV" <susanvoss3@gmail.com> > > To: <alt-photo-process-l@usask.ca> > > Sent: Friday, February 16, 2007 8:40 AM > > Subject: Re: Photopolymer Plate Options > > > > > > > On 2/16/07, Christina Z. Anderson <zphoto@montana.net> wrote: > > >> Jon, Nancy, Keith, etc. etc. > > > > > > "............. I also notice that 100 degree washout for 5-10mn is > > > recommended whereas solarplate requires 68-78 for 2 mn. " > > > > > > > > > That's news to me. I've been doing about 75 for 2 min. > > > > > > ???????????????? > > > > > > Susan > > > > > > www.dalyvoss.com > > > > > > > > > > > > -- > Susan Daly Voss > www.dalyvoss.com > -- Susan Daly Voss www.dalyvoss.com
|