U of S | Mailing List Archive | alt-photo-process-l | Re: Photopolymer Plate Options

Re: Photopolymer Plate Options



Christine...
Didn't see the PDFs at the Boxcar website, but I went to the Toyobo
(manufacturer of Printight plates), and read the info for KM73.  Water
washout is at 15-25C, or 59-77F.
Whew... now I don't have to re-do my tests ;o)
Maybe what you read was for something different?

susan

On 2/16/07, SusanV <susanvoss3@gmail.com> wrote:
Christina... I'm sure your information is right... I just meant that I
was surprised that  I'd somehow missed that, and it may well have a
dramatic effect on my first test results I've just done this week.
I'll go download those PDFs.

thanks!
susan

On 2/16/07, Christina Z. Anderson <zphoto@montana.net> wrote:
> Susan,
> I downloaded the pdfs on EcoEtch Printight KM73 and Ecoetch 43-SB and both
> say that.  Hmmm...
>
> Chris
> ----- Original Message -----
> From: "SusanV" <susanvoss3@gmail.com>
> To: <alt-photo-process-l@usask.ca>
> Sent: Friday, February 16, 2007 8:40 AM
> Subject: Re: Photopolymer Plate Options
>
>
> > On 2/16/07, Christina Z. Anderson <zphoto@montana.net> wrote:
> >> Jon, Nancy,  Keith, etc. etc.
> >
> > ".............  I also notice that 100 degree washout for 5-10mn is
> > recommended whereas solarplate requires 68-78 for 2 mn. "
> >
> >
> > That's news to me.  I've been doing about 75 for 2 min.
> >
> > ????????????????
> >
> > Susan
> >
> > www.dalyvoss.com
> >
>
>
>


--
Susan Daly Voss
www.dalyvoss.com


--
Susan Daly Voss
www.dalyvoss.com