You need an etching press to print the
photopolymer plates. Charles Brand presses can often be found used, but
there are many good quality intaglio presses out there (Takach, Praga,
etc.). I just wouldn't go TOO cheap--to some extent you get what you
pay for. I use a Dickerson combination press in the printmaking studio
where I teach and a Whelan press in my own studio. The Whelan is an
interesting press; it is a large press with a stationary bed and the
roller moves across the bed of the press. It is also unusual in that it
uses a rubber blanket. It may be my imagination, but I sometimes think
that I get better prints from my photopolymer plates using this press
than the traditional style etching press.
Good luck!
Nancy
Nancy W. Diessner
Associate Professor and Chair, Department of Interdisciplinary Studies
Chester College of New England
40 Chester St.
Chester, NH 03036
Weber, Scott wrote:
All this talk about photogravures has inspired me to try this out. I am
going to start looking for a press. My dept. chair said to go as cheap as
possible (used) but will back me up. I need to know exactly which type of
press will print these plates. Is this a lithographers press? Any
information will be appreciated. Also are there sources for this type of
equipment?
Thanks,
Scott B. Weber
Associate Professor of Photography
Department of Fine Arts
Barry University
11300 NE 2nd Avenue
Miami Shores, Florida 33161
(305) 899 4922
The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential, and/or privileged material. No confidentiality or privilege is waived or lost by any errant transmission. If you receive this message in error, please immediately delete it and all copies of it from your system and notify the sender. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses.
Barry University - Miami Shores, FL (http://www.barry.edu)
|