Richard Sullivan (richsul@earthlink.net)
Wed, 17 Mar 1999 09:36:33 -0700
Kerik,
It's the revolver cylinder 8x10 expert drum.
Your idea of the "C" facing outwards makes sense. I'll try it.
--Dick
At 04:36 PM 3/16/99 -0500, you wrote:
>Dick-
>
>> with a clear line running down the width of the print. Developed
>> in a Jobo 8x10 drum in pyro.
>
>Is this a Jobo Expert Drum for 8x10 film or is it a Jobo 8x10 Print drum??
>I've been rotary processing with Pyro for years and I've never had this happen
>in Expert Drums or in my home-made ABS processing tubes.
>
>> I use a Bessler roller and have a devil of a time getting the anti-halation
>> layer off, even if I load wet.
>
>You're using a Jobo Expert Drum, correct? How are you loading the film? I
>find that if I curl the film into a "C", then load it with the opening of the
>"C" facing away from the center of the drum (does that make sense?), then I
>have virtually no problems with the film sticking to the drum or any residual
>anti-halation dye on the back of the film.
>
>Best,
>Kerik
>http://www.jps.net/kerik/
505-474-0890 FAX 505-474-2857
<http://www.bostick-sullivan.com>http://www.bostick-sullivan.com
http://www.workingpictures.com
This archive was generated by hypermail 2.0b3 on Sat Nov 06 1999 - 10:09:03