From: Gordon J. Holtslander (holtsg@duke.usask.ca)
Date: 10/08/02-10:03:48 PM Z
Hi:
A friend of mine made a split back printing frame. He didn't use spring
steel to tension it, but used a piece of wood, an oak laminate I think (he
also builds boats as a hobby). I can ask him how he did this.
Gord
On Tue, 8 Oct 2002, Eric Nelson wrote:
> I had a 20x24 mahogany printing frame made but it had
> no spring backs, just some turn buckles, so I found
> mine through B&S.
> eric
> --- Temi <Temi@TemiOriginals.com> wrote:
> > I hope to build a print-out frame. Two questions
> > have come up - 1/ Where
> > can 'spring steel' be purchased? 2/ Does the
> > thickness of the glass used
> > have any effect on the exposure? - Thanks in advance
> > - Temi
>
>
> __________________________________________________
> Do you Yahoo!?
> Faith Hill - Exclusive Performances, Videos & More
> http://faith.yahoo.com
>
---------------------------------------------------------
Gordon J. Holtslander Dept. of Biology
holtsg@duke.usask.ca 112 Science Place
http://duke.usask.ca/~holtsg University of Saskatchewan
Tel (306) 966-4433 Saskatoon, Saskatchewan
Fax (306) 966-4461 Canada S7N 5E2
---------------------------------------------------------
This archive was generated by hypermail 2.1.5 : 11/14/02-02:40:26 PM Z CST