Scott,
If I understand your question correctly, the output slider in the Levels
command does this.... or you can do the same with the Curves command by moving the
endpoints up & down.
Mark Nelson
In a message dated 12/23/03 7:29:22 PM, smwbmp@starpower.net writes:
> My theroy, being applied to a negative image, is that if I knew the tone of
> a particular shadow density (say 0.20 above media) and a particular
> highlight density (say 2.00 above media), resulting in a density range of 1.80, then
> I could then adjust the tones of the shadows and highlights of my image to
> fit a process requiring a density range of 1.80. Which returns me to my
> question of how to set the shadow and highlight tones.
>
Received on Tue Dec 23 19:59:41 2003
This archive was generated by hypermail 2.1.8 : 01/02/04-09:36:33 AM Z CST