I warmed it a little and everything went back into solution
Thanks to all
Philippe
Ayral a écrit:
> Thanks to all for your explanations.
> All  was dissolved when prepared months ago, deposit is quite new, 
> just few weeks ago.
> I will try to warm it up and see what happens.
>
> Philippe
> http://perso.club-internet.fr/payral
>
>
> Jeffrey D. Mathias a écrit:
>
>> Ayral wrote:
>>
>>> I found some deposit at the bottom of my platinum bottle (Pot. 
>>> Chloroplatinite )
>>> Should I leave it like that or is there a way to dissolve it again.
>>> Shaking the bottle doesn't work.
>>
>>
>>
>> There may be a couple possibilities even for those who are careful 
>> and clean.
>>
>> a) It is K2PtCl4.  Depending on the solution strength and the 
>> temperature there may be some deposit.  This is OK and normal.  What 
>> needs to be done is to warm the solution before and during use in a 
>> warm water bath that is at the temperature to keep all the metal salt 
>> in solution.  "However it is recommended to not go warmer than 140F.  
>> It is normal that typical Pt solutions will require a temperature 
>> greater than the room. [Note: It is not recommended to warm the room 
>> as the coating process in general seems to work better around 60F.]
>>
>> If the deposit is present and not in solution then the coating may 
>> not have enough Pt and the print will be weak.  It is very unlikely 
>> that this will produce black specks as this double metal salt is 
>> soluble in water and will wash off during processing.
>>
>> b) It is K2PtCl6.  This is bad as this salt is only slightly soluble 
>> in water and no amount of warming or shaking will help.  Although 
>> this can be formed at temperatures over 140F in the presence of 
>> sodium, the likely source is contamination or an impurity of the raw 
>> double salt. This is from the manufacturer.  This can be a cause of 
>> black specks in the print.
>>
>
-- Philippe Ayral 52, rue de Vallard 74240 Gaillard France Tél/Fax: +33 (0)450 39 79 81 http://perso.club-internet.fr/payral http://www.focale.chReceived on Sun Dec 12 10:58:22 2004
This archive was generated by hypermail 2.1.8 : 01/03/05-09:29:43 AM Z CST