Re: Halo or Fogging at Edge of Digital Negative

Oooops, the cat stomped on the "send" key before I was done. I guess I
better
give the cat-a-tonic to calm him down.

I let my negatives "cure" about a couple of hours at least. My usual
practice is to print the negatives the day before I make prints. The density range
of the negative will drop as it cures.

Mark Nelson
Purchase the eBook & System for Your Own Custom Workflow@
Precision Digital Negatives
PDN's Own 31-Step Tablet Now Available—produced by Stouffer Industries
Credit Card & Paypal now accepted
www.MarkINelsonPhoto.com
Workshop info on Home Page

In a message dated 2/22/05 7:46:23 PM, Ender100@aol.com writes:

> This should disappear after about an hour or two—if it's still there the
> next day I'd
>
> In a message dated 2/22/05 7:41:53 PM, mkochsch@shaw.ca writes:
>
>
>
> I'm noticing a halo or translucent fogging at the edges of a digital
> negative I just made tonight. It kind of looks like what you get from
> breathing on a window on a cold night -- except it's not going away. Is it
> common to find this on inkjet negatives? I'm guessing it's some sort of
> off-gassing of what? Ammonia? I threw the negative in a report cover very
> soon after printing it. Do others let their inkjet negatives "air out"? Thx.
>
>
Received on Tue Feb 22 20:04:34 2005