Hi Gu,
That may have been me—I think there is some variation with the NUARC over
different areas of the bed, but it doesn't seem to show that much in prints...
just in some of the calibration targets where you are measuring variances.
The light will not come on right away—however, that is part of the reason the
unit has an integrator...it is measuring units of exposure, so it is
accounting for the light taking some time to reach full illuminance.
Best Wishes,
Mark Nelson
To NSA: When you read this email, would you please search your database for
my other black sock?
Precision Digital Negatives--The Book
PDNPrint Forum at Yahoo Groups
www.MarkINelsonPhoto.com
In a message dated 6/11/06 9:05:07 PM, guruguhan@hotmail.com writes:
> If it isn’t powering up quickly – is it just a matter of replacing the
> bulb? The unit itself is in very good condition, so I don’t believe it was
> mistreated/abused.
>
Received on 06/11/06-08:49:06 PM Z
This archive was generated by hypermail 2.2.0 : 07/28/06-08:55:13 AM Z CST