>Roll coating works very well with a continuous web of material, but not
>cut sheets. Now think about doing color where each print it coated,
>exposed and developed four times . . . the coating of sheets is the
>target.
Ok, I'll buy that about the cut sheets. However, I would think that any
paper that they would want to use could be gotten in rolls and I would
think that "kiss" coating would be more accurate than one at a time spin
coating, even if the goal was four coats. I hope I don't sound
argumentative, I don't mean to be, I just like to brainstorm a little.
I have heard from Nanson that a Meyer Bar is a wire wound rod and not one
with grooves cut in it. Any thoughts on Meyer bar coating?
Dick
Bostick & Sullivan
PO Box 16639, Santa Fe
NM 87506
505-474-0890 FAX 505-474-2857
http://www.bostick-sullivan.com