From: Eric Neilsen (e.neilsen@worldnet.att.net)
Date: 04/17/00-12:55:49 PM Z
Kerik and Bob,
Are you coating the entire piece of vellum or only a specific area within the edges of the vellum? this may account for some of the problems of the uneven surface after drying.
Kerik717@aol.com wrote:
>
> The Wyndstone Vellum comes in several thicknesses. I've worked with the 5 point and 2 point sizes. The 2 point (thinner) is somewhat easier to flatten than the 5 point, but it's still a problem. It helps to print on a sheet that is much larger than the image, and then trim it down after you've dried and flattened it as much as possible. The paper is very inexpensive, so this is not a costly approach. Prints on this paper are exquisite, if you can overcome the wrinkling.
>
> Kerik Kouklis
> www.Kerik.com
-- Eric J. Neilsen 4101 Commerce Street, Suite #9 Dallas, TX 75226 214-827-8301 http://e.neilsen.home.att.net http://www.ericneilsenphotography.com
This archive was generated by hypermail 2b29 : 06/13/00-03:09:48 PM Z CST