From: garimo (omirag@cruzio.com)
Date: 07/22/01-03:50:40 PM Z
>I use soft rubber caps that are made for the ABS pipe. Easy to remove from
>any size pipe. I got them at a Home Depot-like store where I buy 3" and 4"
>diameter ABS pipe to make the tubes. Cost for one 7x17 processing tube with
>rubber caps is about $7. Very cheap!
>
>Kerik
Hey Kerik... I made a tube this same way, but haven't yet used it. Was
afraid it needed some sort of ribbing inside so the chemistry would
flow around the film, as it does with the other tank I have. Is the
inside of your ABS tank smooth? and the film fits up against the walls
of the tube? no sticking when you try to remove the film??
garimo
This archive was generated by hypermail 2b30 : 08/02/01-11:56:47 AM Z CST