From: Gary Beasley (beasleyglb@mindspring.com)
Date: 10/24/01-01:27:43 PM Z
At 08:06 AM 10/24/01 -0700, you wrote:
>Thank you for your reply
>This thing is pretty old. I think it was made for
>making litho plates. I have a handful of rods, any
>idea how long they last? I can vent it without to much
>trouble.
>I think I am leaning towards just leaving it and using
>it as is.
>Again, thank you for your response.
It's been a very long time but I remember we would change the rods in the
plateburner every couple of days and we made at least a dozen plates a day
with a two to three minute burn each. With occasional use they will last a
good while. Is the machine self adjusting or do you have to strike the arc
manually? Be really careful with your eyes as this is the same kind of
light an arc welder makes. Be sure the connections are very tight as a
loose one will burn up quickly from the amp load.
>__________________________________________________
>Do You Yahoo!?
>Make a great connection at Yahoo! Personals.
>http://personals.yahoo.com
This archive was generated by hypermail 2b30 : 11/02/01-08:55:27 AM Z CST