RE: contact printing frames

From: Vincent Dobson (manitec@bellsouth.net)
Date: 07/08/03-07:15:22 AM Z

• Next message: Larry Roohr: "Re: contact printing frames"
• Previous message: Joachim Oppenheimer: "vacuum v frames"
• In reply to: Dave Rose: "Re: contact printing frames"
• Next in thread: Larry Roohr: "Re: contact printing frames"
• Reply: Larry Roohr: "Re: contact printing frames"
• Reply: Dave Rose: "Homemade vacuum frame (was: contact printing frames)"

<:)-----Original Message-----
<:)From: Dave Rose [mailto:cactuscowboy@bresnan.net]
<:)My homemade vacuum frame was assembled in an afternoon. It was easy to
<:)build and inexpensive. With it I can print tack-sharp contact
<:)prints

Hi,

Good news, but just two questions?

How do you (or can you) view to check development without losing
registration?

And --- How did you drill all those little holes? Did you use something
stock for this. I would think pegboard holes would be too large and too
few.

Thanks

Vince Dobson
Visions In Nature
www.VisionsInNature.com

• Next message: Larry Roohr: "Re: contact printing frames"
• Previous message: Joachim Oppenheimer: "vacuum v frames"
• In reply to: Dave Rose: "Re: contact printing frames"
• Next in thread: Larry Roohr: "Re: contact printing frames"
• Reply: Larry Roohr: "Re: contact printing frames"
• Reply: Dave Rose: "Homemade vacuum frame (was: contact printing frames)"

This archive was generated by hypermail 2.1.5 : 08/07/03-03:34:49 PM Z CST