thanks for the answer terry. the tube i am using holds 200ml and i have just always used that amount. perhaps i should try 100ml and see if i get enough coverage. thanks again
[input] [input] [input] [input]
Pyrocat-HD is meant to be used as a one-shot and discard developer.
With this type of processing you need a minimum of about 75ml of the
1:1:100 solution for processing a sheet of 5X7 film. 200ml of the
2:2:100 is quite a bit more than would be needed for one sheet of
film, so I believe you could use it again for a second sheet, though
you will probably get more B+F and slighly less contrast the second
time. Why not just split the developer into two 100ml units and
process each sheet separately?
Sandy
>I have a situation where I have only one tube to develop 5x7 film.
>If I use a 2:2:100 mix (200ml for a single sheet) on Efke 100, can I
>use the developer for a second sheet?..or should it be considered a
>single use? I'm hoping to get usable negs for van dyke printing?
Received on Thu Mar 30 15:06:32 2006
This archive was generated by hypermail 2.1.8 : 04/10/06-09:43:47 AM Z CST