U of S | Mailing List Archive | alt-photo-process-l | Re: Cutting polymer plates

Re: Cutting polymer plates


I've printed in editions of 50 +5 APs. As long as you're careful with pressure etc. it can be done without too much degradation, but I wouldn't want to do it for everything. 20-25 is a reasonable number.


On Mar 13, 2007, at 2:27 PM, Jon Lybrook wrote:

On the subject of durability, I spoke with a picky client recently who does lots of editioning and he says they typically don't get more than 30 prints out of a solarplate before the tone and sharpness diminish. I assume the same or less is true for the KM73s. Most I've done is editions of 20 with some changes, but not an unacceptable loss of quality after 20.