Ender100@aol.com
Date: 04/11/02-07:38:53 AM Z
Shannon,
You might check to see if the paper thickness lever is properly set.... or
make sure you are set at one direction printing in slowest mode.....
Also, you can play with different media settings and printer resolution.
One thing to check is to measure the actual vertical height of the printed
area and compare to the vertical dimension of the image in Photoshop... if it
is longer on the printed image, then it may have to do with paper handling...
Oh...did you run a nozzle check?
Mark Nelson
In a message dated 4/11/02 8:56:09 AM, sstoney@pdq.net writes:
<<
>
>Sorry Shannon, but I have no information to share with you about how
>to stop banding other than what is in the Epson 2000P printer
>manual. I have had a few problems with this printer in the past that
>cleared up with an overnight rest so maybe you and the printer just
>need to take a break. Make sure you put Pictorico in the printer
>with the right orientation of course, with the notch at the top
>right as you hold it up to place in the tray.
I will try again today. >>
This archive was generated by hypermail 2b30 : 05/01/02-11:43:29 AM Z CST