Re: Humidity and Sensitivity... Platinum  and so on...

Thanks, Mark- I do believe you are right about the humidity levels being neglected.
I found about it the hard way, after seeing my POP go "off". I finally bought a hygrometer and was surprised to see the levels go above 50% even with film processing. I'm sure people on the coasts experience the same problem?
See you, Susan.
www.susanhuber.com
  ----- Original Message -----
  From: Ender100@aol.com
  To: alt-photo-process-l@sask.usask.ca
  Sent: Thursday, August 05, 2004 10:28 AM
  Subject: Re: Humidity and Sensitivity... Platinum and so on...

  Eric,

  Very well said.

  I became fully aware of the effect of temperature and humidity with PT/PD when I was putting together the Precision Digital Negative system. It was really driven home late last fall when the furnace kicked in and printing suddenly went to pieces. I bought a nice little digital thermometer/hygrometer from Ace Hardware for about $20. That coupled with a nice little Holms Humidifier has resulted in no problem since then. I found that maintaining a level of relative humidity in the 50-60% range was important to good printing with PT/PD and had this confirmed by a number of expert printers.

  I finally standardized on a specific humidity level and a method of pre-humidifying my paper before coating and a specific drying time and method. The system I am using for printing with digital negatives will indicate very slight variances.

  It is much easier to control a situation where you have low humidity than high humidity, since it is easier to add than subtract. Places where there is very very high humidity on a regular basis must present a real problem.

  I think people around the country have very different humidity issues or non-issues, depending on the consistency of the relative humidity and variance with seasons. Most people have probable just built it into their workflow—sometimes without being aware that they were doing so, but getting good results just the same. I think it is probably one of the most important and most ignored issues in printing.

  Mark Nelson
  www.precisiondigitalnegatives.com

  In a message dated 8/5/04 9:45:30 AM, e.neilsen@worldnet.att.net writes:

    Ray, Heat and Humidity are ALWAYS important throughout the process. That
    being said, it is not always critical nor does it remain the same issue at
    each phase of the print production process. The paper will get treated by
    the practitioner before the coating of the sensitizer, gum, sizing, et la.
    The coated paper is then handled carefully to the next step, and so on until
    the finished print lay on the table with the eyes of its creator lovingly
    looking down upon it. With the platinum/palladium family of print making,
    humidity affects the way the coating solution is absorbed and thus how much
    or how little solution to use. In the drying of the paper, it
    allows/prevents the penetration of the solution. In the exposure it plays a
    roll in speed, color and contrast.

    AS you print, you begin to see how critical control of humidity and heat
    become. This understanding and others like it can allow you to control the
    process rather than it controlling you.

    Have fun!

    Eric Neilsen Photography
    4101 Commerce Street
    Suite 9
    Dallas, TX 75226
    http://e.neilsen.home.att.net
    http://ericneilsenphotography.com
Received on Mon Aug 9 12:02:01 2004